P1AE3 Sunbeam-talbot Rapier Diagnostic Trouble Code

P1AE3 Sunbeam-talbot Rapier code definition:
P1AE3 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Sunbeam-talbot Rapier.

P1AE3 Sunbeam-talbot Rapier shows up when there's an electrical problem that causes the fuel volume regulator to malfunction and open. It's quite an unusual problem and likely intermittent. Any code that causes the vehicle's engine to die while running should be fixed as soon as possible, as it can be dangerous for both the vehicle and the passengers of the vehicle.

Symptoms

Symptoms of a P1AE3 Sunbeam-talbot Rapier diagnostic trouble code may include:

The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
Faulty or damaged wiring
Hesitation upon acceleration
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Defective ECU strategies or components will prevent proper regeneration

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition.

Process Tips

Diagnostic trouble code P1AE3 Sunbeam-talbot Rapier is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1AE3 Sunbeam-talbot Rapier.

Fortunately, P1AE3 Sunbeam-talbot Rapier is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.