P1AAE Knox Model O Diagnostic Trouble Code

P1AAE Knox Model O code definition:
P1AAE is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Knox Model O.

P1AAE Knox Model O is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. The spark should have a light tan color. If the sensor probe comes with white and chalky parts, this means it has been lagging between switching phases, and should be replaced.

Symptoms

Symptoms of a P1AAE Knox Model O diagnostic trouble code may include:

Excessive exhaust leak
Hesitation upon acceleration
Malfunction Indicator Lamp (MIL) illuminated
Engine surge

Possible Causes :

Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code P1AAE Knox Model O is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1AAE Knox Model O.

Fortunately, P1AAE Knox Model O is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.