P1A6C Nissan Pulsar Diagnostic Trouble Code

P1A6C Nissan Pulsar code definition:
P1A6C is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Nissan Pulsar.

P1A6C Nissan Pulsar is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a P1A6C Nissan Pulsar diagnostic trouble code may include:

Poor fuel economy
Possible spark knock (detonation / pre-ignition)
Misfire
The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly

Possible Causes :

A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.
Faulty IMRC actuator/sensor
A plugged converter will cause of host of driveability problems as well as set this code. A severely plugged converter will result in the inability to increase rpm when under load. Look for a code such as P0421 -- catalytic converter efficiency below threshold if the converter indicating a faulty converter.

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Now, clear the codes and test-drive the vehicle to see if the code is reset. Look for damage to the tank indicating impact that may have damaged the fuel pump or sender.

Process Tips

Diagnostic trouble code P1A6C Nissan Pulsar is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1A6C Nissan Pulsar.

Fortunately, P1A6C Nissan Pulsar is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.