P196E Jeep Renegade Diagnostic Trouble Code

P196E Jeep Renegade code definition:
P196E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Jeep Renegade.

P196E Jeep Renegade or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P196E Jeep Renegade diagnostic trouble code may include:

Cherry red hot catalytic converter
Poor acceleration
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.

Process Tips

Diagnostic trouble code P196E Jeep Renegade is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P196E Jeep Renegade.

Fortunately, P196E Jeep Renegade is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.