P190F Triumph Tiger Diagnostic Trouble Code

P190F Triumph Tiger code definition:
P190F is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Triumph Tiger.

P190F Triumph Tiger is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P190F Triumph Tiger diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

Look at the plug wires to make sure they are not burnt or laying on the exhaust. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors.

Process Tips

Diagnostic trouble code P190F Triumph Tiger is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P190F Triumph Tiger.

Fortunately, P190F Triumph Tiger is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.