P1909 Mitsubishi Concept Diagnostic Trouble Code

P1909 Mitsubishi Concept code definition:
P1909 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Mitsubishi Concept.

P1909 Mitsubishi Concept is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P1909 Mitsubishi Concept diagnostic trouble code may include:

Vacuum leak on the engine
Reduction in engine performance, especially at low RPM levels
Engine surge
Hesitation upon acceleration

Possible Causes :

A plugged converter will cause of host of driveability problems as well as set this code. A severely plugged converter will result in the inability to increase rpm when under load. Look for a code such as P0421 -- catalytic converter efficiency below threshold if the converter indicating a faulty converter.
Dirty air cleaner element Damaged DPF
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Look for damage to the tank indicating impact that may have damaged the fuel pump or sender.

Process Tips

Diagnostic trouble code P1909 Mitsubishi Concept is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1909 Mitsubishi Concept.

Fortunately, P1909 Mitsubishi Concept is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.