P141F Glas 3000 Diagnostic Trouble Code

P141F Glas 3000 code definition:
P141F is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Glas 3000.

P141F Glas 3000 or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P141F Glas 3000 diagnostic trouble code may include:

Fuel pressure too high
Diminished fuel efficiency
Rich or lean exhaust
Engine surge

Possible Causes :

Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
An air leak forward of the DPF will change the sensor readings resulting in the code
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code P141F Glas 3000 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P141F Glas 3000.

Fortunately, P141F Glas 3000 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.