P125E Daimler Super Diagnostic Trouble Code

P125E Daimler Super code definition:
P125E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Daimler Super.

P125E Daimler Super is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P125E Daimler Super diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Faulty IMRC actuator/sensor

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code P125E Daimler Super is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P125E Daimler Super.

Fortunately, P125E Daimler Super is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.