P1240 Hyundai Dynasty Diagnostic Trouble Code

P1240 Hyundai Dynasty code definition:
P1240 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Hyundai Dynasty.

P1240 Hyundai Dynasty is defined as Ignition Coil B Primary/Secondary Circuit Malfunction.This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II tool, or vehicles made since 1996 up to present. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a P1240 Hyundai Dynasty diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code P1240 Hyundai Dynasty is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1240 Hyundai Dynasty.

Fortunately, P1240 Hyundai Dynasty is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.