P1226 Steyr-puch 650 Diagnostic Trouble Code

P1226 Steyr-puch 650 code definition:
P1226 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Steyr-puch 650.

P1226 Steyr-puch 650 is described as Intake Air Temperature (IAT) Circuit Malfunction. It's actually a general trouble code for a problem on IAT electrical circuit sensor, as it sends incorrect voltage input signals to the PCM. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P1226 Steyr-puch 650 diagnostic trouble code may include:

Faulty or damaged wiring
The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
Poor fuel economy
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code P1226 Steyr-puch 650 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1226 Steyr-puch 650.

Fortunately, P1226 Steyr-puch 650 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.