P11CB Saab 9.3 Diagnostic Trouble Code

P11CB Saab 9.3 code definition:
P11CB is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Saab 9.3.

P11CB Saab 9.3 is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a P11CB Saab 9.3 diagnostic trouble code may include:

The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
Faulty or damaged wiring
Hesitation upon acceleration
Diminished fuel efficiency

Possible Causes :

The Mass Airflow sensor is a hot wire that senses the volume of air entering the intake manifold. The computer uses this information to control fuel mixture.
Defective ECU strategies or components will prevent proper regeneration
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Now, clear the codes and test-drive the vehicle to see if the code is reset.

Process Tips

Diagnostic trouble code P11CB Saab 9.3 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P11CB Saab 9.3.

Fortunately, P11CB Saab 9.3 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.