P116B Abarth Mono Diagnostic Trouble Code

P116B Abarth Mono code definition:
P116B is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Abarth Mono.

P116B Abarth Mono is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P116B Abarth Mono diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors.

Process Tips

Diagnostic trouble code P116B Abarth Mono is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P116B Abarth Mono.

Fortunately, P116B Abarth Mono is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.