P1042 Mercedes Cl 63 Diagnostic Trouble Code

P1042 Mercedes Cl 63 code definition:
P1042 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Mercedes Cl 63.

P1042 Mercedes Cl 63 is defined as Ignition Coil B Primary/Secondary Circuit Malfunction.This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II tool, or vehicles made since 1996 up to present. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P1042 Mercedes Cl 63 diagnostic trouble code may include:
Place of P1042 in engine

Possible Causes :

  • Faulty IMRC actuator relay (if equipped)
  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

  1. Exhaust Gas Recirculation System Valve 1 Problem
  2. BBV Sensor Circuit Low Voltage Problem
  3. Transmission Engaged At High Throttle Angle Problem
  4. Cruise Inhibit Control Circuit Problem
  5. TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code P1042 Mercedes Cl 63 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1042 Mercedes Cl 63.

Fortunately, P1042 Mercedes Cl 63 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2024 - https://DiagnosticTrouble.com

Small Logo