P100F Fiat Abarth Diagnostic Trouble Code

P100F Fiat Abarth code definition:
P100F is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Fiat Abarth.

P100F Fiat Abarth is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a P100F Fiat Abarth diagnostic trouble code may include:

Poor fuel economy
Possible spark knock (detonation / pre-ignition)
Misfire
Engine surge

Possible Causes :

Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
An air leak forward of the DPF will change the sensor readings resulting in the code
A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code P100F Fiat Abarth is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P100F Fiat Abarth.

Fortunately, P100F Fiat Abarth is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.