P0AE6 Daihatsu Move Diagnostic Trouble Code
P0AE6 Daihatsu Move code definition:
P0AE6 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Daihatsu Move.
P0AE6 Daihatsu Move is defined as Ignition Coil B Primary/Secondary Circuit Malfunction.This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II tool, or vehicles made since 1996 up to present. So if the problem persists despite of your diagnosis, then you should never hesitate to take your vehicle to your dealer or to a qualified mechanic.
Symptoms
Symptoms of a P0AE6 Daihatsu Move diagnostic trouble code may include:
- Poor acceleration
- Cherry red hot catalytic converter
- Possible spark knock (detonation / pre-ignition)
- If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
|
Possible Causes :
- A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
- Faulty IMRC actuator relay (if equipped)
- A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
|
Common Misdiagnoses
- Crankshaft Position Sensor Circuit Performance Problem
- TP Sensor Learn Not Complete Problem
- Low Coolant Circuit Problem
- Cruise Control System - Vehicle Accel Too High Problem
- Kick-Down Switch Failed Short Problem
Repair Processes :
If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve.
Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.
Process Tips
Diagnostic trouble code P0AE6 Daihatsu Move is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.
Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0AE6 Daihatsu Move.
Fortunately, P0AE6 Daihatsu Move is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.
Diagnostic Trouble Code look-up and check engine light code viewer.
About Us | Contact | Privacy
Copyright 2024 - https://DiagnosticTrouble.com