P0841 Sunbeam Alpine Diagnostic Trouble Code

P0841 Sunbeam Alpine code definition:
P0841 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Sunbeam Alpine.

P0841 Sunbeam Alpine is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a P0841 Sunbeam Alpine diagnostic trouble code may include:

Corroded or damaged connector
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Lack of power
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.

Process Tips

Diagnostic trouble code P0841 Sunbeam Alpine is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0841 Sunbeam Alpine.

Fortunately, P0841 Sunbeam Alpine is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.