P07C2 Sunbeam-talbot Rapier Diagnostic Trouble Code

P07C2 Sunbeam-talbot Rapier code definition:
P07C2 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Sunbeam-talbot Rapier.

P07C2 Sunbeam-talbot Rapier shows up when there's an electrical problem that causes the fuel volume regulator to malfunction and open. It's quite an unusual problem and likely intermittent. Any code that causes the vehicle's engine to die while running should be fixed as soon as possible, as it can be dangerous for both the vehicle and the passengers of the vehicle.

Symptoms

Symptoms of a P07C2 Sunbeam-talbot Rapier diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code P07C2 Sunbeam-talbot Rapier is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P07C2 Sunbeam-talbot Rapier.

Fortunately, P07C2 Sunbeam-talbot Rapier is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.