P0749 Packard 200 Diagnostic Trouble Code

P0749 Packard 200 code definition:
P0749 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Packard 200.

P0749 Packard 200 is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. Any code that causes the vehicle's engine to die while running should be fixed as soon as possible, as it can be dangerous for both the vehicle and the passengers of the vehicle.

Symptoms

Symptoms of a P0749 Packard 200 diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code P0749 Packard 200 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0749 Packard 200.

Fortunately, P0749 Packard 200 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.