P068E Gaz M-20 Diagnostic Trouble Code

P068E Gaz M-20 code definition:
P068E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Gaz M-20.

P068E Gaz M-20 is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. Any code that causes the vehicle's engine to die while running should be fixed as soon as possible, as it can be dangerous for both the vehicle and the passengers of the vehicle.

Symptoms

Symptoms of a P068E Gaz M-20 diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Now, clear the codes and test-drive the vehicle to see if the code is reset. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.

Process Tips

Diagnostic trouble code P068E Gaz M-20 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P068E Gaz M-20.

Fortunately, P068E Gaz M-20 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.