P03C7 Sunbeam 12 Diagnostic Trouble Code

P03C7 Sunbeam 12 code definition:
P03C7 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Sunbeam 12.

P03C7 Sunbeam 12 is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a P03C7 Sunbeam 12 diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Engine surge

Possible Causes :

Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Use the DVOM to test resistance and continuity on all system circuits if actuator and sensor resistance levels are in compliance with manufacturer's specifications.

Process Tips

Diagnostic trouble code P03C7 Sunbeam 12 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P03C7 Sunbeam 12.

Fortunately, P03C7 Sunbeam 12 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.