P03B8 Subaru Pleo Diagnostic Trouble Code

P03B8 Subaru Pleo code definition:
P03B8 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Subaru Pleo.

P03B8 Subaru Pleo is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. The spark should have a light tan color. If the sensor probe comes with white and chalky parts, this means it has been lagging between switching phases, and should be replaced.

Symptoms

Symptoms of a P03B8 Subaru Pleo diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
Hesitation upon acceleration

Possible Causes :

Some aftermarket accessories and performance modifications
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data.

Process Tips

Diagnostic trouble code P03B8 Subaru Pleo is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P03B8 Subaru Pleo.

Fortunately, P03B8 Subaru Pleo is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.