P0212 Nissan Be-1 Diagnostic Trouble Code

P0212 Nissan Be-1 code definition:
P0212 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Nissan Be-1.

P0212 Nissan Be-1 is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P0212 Nissan Be-1 diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Faulty IMRC actuator/sensor

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.

Process Tips

Diagnostic trouble code P0212 Nissan Be-1 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0212 Nissan Be-1.

Fortunately, P0212 Nissan Be-1 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.