P011F Rover 200 Diagnostic Trouble Code

P011F Rover 200 code definition:
P011F is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Rover 200.

P011F Rover 200 is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P011F Rover 200 diagnostic trouble code may include:

Misfire
Misfire
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly

Possible Causes :

A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.
Faulty IMRC actuator/sensor
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code P011F Rover 200 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P011F Rover 200.

Fortunately, P011F Rover 200 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.