P0105 Salmson 2300 Diagnostic Trouble Code

P0105 Salmson 2300 code definition:
P0105 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Salmson 2300.

P0105 Salmson 2300 or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a P0105 Salmson 2300 diagnostic trouble code may include:
Place of P0105 in engine

Possible Causes :

  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • Faulty IMRC actuator relay (if equipped)
  • An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

  1. TP Sensor Learn Not Complete Problem
  2. Low Coolant Circuit Problem
  3. Cruise Control System - Vehicle Accel Too High Problem
  4. TFP Valve Position Switch-Drive Without Drive Ratio Problem
  5. Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code P0105 Salmson 2300 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0105 Salmson 2300.

Fortunately, P0105 Salmson 2300 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2022 - https://DiagnosticTrouble.com

Small Logo