P0091 Datsun 120 Diagnostic Trouble Code

P0091 Datsun 120 code definition:
P0091 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Datsun 120.

P0091 Datsun 120 is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P0091 Datsun 120 diagnostic trouble code may include:

Hesitation upon acceleration
Excessive exhaust leak
Rich or lean exhaust
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
Some aftermarket accessories and performance modifications

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.

Process Tips

Diagnostic trouble code P0091 Datsun 120 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0091 Datsun 120.

Fortunately, P0091 Datsun 120 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.