P0034 Volkswagen Polo 5 Diagnostic Trouble Code

P0034 Volkswagen Polo 5 code definition:
P0034 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Volkswagen Polo 5.

P0034 Volkswagen Polo 5 is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a P0034 Volkswagen Polo 5 diagnostic trouble code may include:
  • The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
  • Faulty PCM
  • If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
  • Diminished fuel efficiency
Place of P0034 in engine

Possible Causes :

  • Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
  • Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
  • An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

  1. Vehicle Speed Output Circuit Problem
  2. Cruise Control Servo Indicates Low Problem
  3. A/C System High Pressure High Temperature Problem
  4. PCM Stack Overrun Problem
  5. Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Look at the plug wires to make sure they are not burnt or laying on the exhaust. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.

Process Tips

Diagnostic trouble code P0034 Volkswagen Polo 5 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0034 Volkswagen Polo 5.

Fortunately, P0034 Volkswagen Polo 5 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2021 - https://diagnosticTrouble.com

Small Logo