P0008 Subaru Sagres Diagnostic Trouble Code
P0008 Subaru Sagres code definition:
P0008 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Subaru Sagres.
P0008 Subaru Sagres is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.
Symptoms
Symptoms of a P0008 Subaru Sagres diagnostic trouble code may include:
- Faulty or damaged wiring
- The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
- Poor fuel economy
- Diminished fuel efficiency
|
Possible Causes :
- The Mass Airflow sensor is a hot wire that senses the volume of air entering the intake manifold. The computer uses this information to control fuel mixture.
- Defective ECU strategies or components will prevent proper regeneration
- A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.
|
Common Misdiagnoses
- Exhaust Gas Recirculation System Valve 1 Problem
- BBV Sensor Circuit Low Voltage Problem
- Transmission Engaged At High Throttle Angle Problem
- Cruise Inhibit Control Circuit Problem
- TFP Valve Position Switch-Drive Without Drive Ratio Problem
Repair Processes :
With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.
It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.
Process Tips
Diagnostic trouble code P0008 Subaru Sagres is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.
Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P0008 Subaru Sagres.
Fortunately, P0008 Subaru Sagres is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.
Diagnostic Trouble Code look-up and check engine light code viewer.
About Us | Contact | Privacy
Copyright 2024 - https://DiagnosticTrouble.com
![Small Logo](https://diagnostictrouble.com/images/logo.png)