C3203 Mitsubishi Lancer Evo 10 Diagnostic Trouble Code

C3203 Mitsubishi Lancer Evo 10 code definition:
C3203 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Mitsubishi Lancer Evo 10.

C3203 Mitsubishi Lancer Evo 10 is a DTC or a diagnostic trouble code. It is a check engine light code which indicates that the catalyst's system efficiency is less than the required threshold. In simple terms, it means that more pollution is added into the air than what was supposed to be because of your car. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a C3203 Mitsubishi Lancer Evo 10 diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors.

Process Tips

Diagnostic trouble code C3203 Mitsubishi Lancer Evo 10 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C3203 Mitsubishi Lancer Evo 10.

Fortunately, C3203 Mitsubishi Lancer Evo 10 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.