C2847 Mazda Rx-4 Diagnostic Trouble Code

C2847 Mazda Rx-4 code definition:
C2847 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Mazda Rx-4.

C2847 Mazda Rx-4 or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. So if the problem persists despite of your diagnosis, then you should never hesitate to take your vehicle to your dealer or to a qualified mechanic.

Symptoms

Symptoms of a C2847 Mazda Rx-4 diagnostic trouble code may include:

Lack of power
Faulty O2 Sensor
Poor acceleration
Engine surge

Possible Causes :

Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Use the DVOM to test resistance and continuity on all system circuits if actuator and sensor resistance levels are in compliance with manufacturer's specifications. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code C2847 Mazda Rx-4 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C2847 Mazda Rx-4.

Fortunately, C2847 Mazda Rx-4 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.