C256C Alvis 10 Diagnostic Trouble Code

C256C Alvis 10 code definition:
C256C is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Alvis 10.

C256C Alvis 10 is defined as Ignition Coil B Primary/Secondary Circuit Malfunction.This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II tool, or vehicles made since 1996 up to present. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a C256C Alvis 10 diagnostic trouble code may include:

If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Corroded or damaged connector
Reduction in engine performance, especially at low RPM levels
Engine surge

Possible Causes :

Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
An air leak forward of the DPF will change the sensor readings resulting in the code
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition. You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code C256C Alvis 10 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C256C Alvis 10.

Fortunately, C256C Alvis 10 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.