C244E Sunbeam Rapier Diagnostic Trouble Code

C244E Sunbeam Rapier code definition:
C244E is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Sunbeam Rapier.

C244E Sunbeam Rapier is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a C244E Sunbeam Rapier diagnostic trouble code may include:

Excessive exhaust leak
Hesitation upon acceleration
Malfunction Indicator Lamp (MIL) illuminated
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code C244E Sunbeam Rapier is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C244E Sunbeam Rapier.

Fortunately, C244E Sunbeam Rapier is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.