C2447 Hillman Hunter Diagnostic Trouble Code

C2447 Hillman Hunter code definition:
C2447 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Hillman Hunter.

C2447 Hillman Hunter is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a C2447 Hillman Hunter diagnostic trouble code may include:

Misfire
Misfire
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Engine surge

Possible Causes :

Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
An air leak forward of the DPF will change the sensor readings resulting in the code
Defective ECU strategies or components will prevent proper regeneration

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition. If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code C2447 Hillman Hunter is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C2447 Hillman Hunter.

Fortunately, C2447 Hillman Hunter is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.