C222E Darracq 2.5-litre Diagnostic Trouble Code

C222E Darracq 2.5-litre code definition:
C222E is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Darracq 2.5-litre.

C222E Darracq 2.5-litre is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a C222E Darracq 2.5-litre diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.

Process Tips

Diagnostic trouble code C222E Darracq 2.5-litre is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C222E Darracq 2.5-litre.

Fortunately, C222E Darracq 2.5-litre is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.