C2143 Batten 3.6 Diagnostic Trouble Code

C2143 Batten 3.6 code definition:
C2143 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Batten 3.6.

C2143 Batten 3.6 is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. As you drive and when specific conditions are slowly met, the vapors will gradually purge from the charcoal canister and will get burned within your engine.

Symptoms

Symptoms of a C2143 Batten 3.6 diagnostic trouble code may include:

Lack of power
Faulty O2 Sensor
Poor acceleration
Rich or lean exhaust

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code C2143 Batten 3.6 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C2143 Batten 3.6.

Fortunately, C2143 Batten 3.6 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.