C1390 Sunbeam 10 Diagnostic Trouble Code

C1390 Sunbeam 10 code definition:
C1390 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Sunbeam 10.

C1390 Sunbeam 10 is described as Oxygen Sensor Circuit No Activity Detected (Bank 1, Sensor 1). This means there's a problem in the front oxygen sensor on Bank 1, as the O2 sensor is inactive. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a C1390 Sunbeam 10 diagnostic trouble code may include:

Fuel pressure too low
Rich or lean exhaust
Diminished fuel efficiency
Hesitation upon acceleration

Possible Causes :

Some aftermarket accessories and performance modifications
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Faulty IMRC actuator/sensor

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed.

Process Tips

Diagnostic trouble code C1390 Sunbeam 10 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C1390 Sunbeam 10.

Fortunately, C1390 Sunbeam 10 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.