C1175 Nissan Rogue 2 Diagnostic Trouble Code

C1175 Nissan Rogue 2 code definition:
C1175 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Nissan Rogue 2.

C1175 Nissan Rogue 2 is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a C1175 Nissan Rogue 2 diagnostic trouble code may include:
  • Poor acceleration
  • Cherry red hot catalytic converter
  • Possible spark knock (detonation / pre-ignition)
  • Hesitation upon acceleration
Place of C1175 in engine

Possible Causes :

  • Some aftermarket accessories and performance modifications
  • A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

  1. Exhaust Gas Recirculation System Valve 1 Problem
  2. BBV Sensor Circuit Low Voltage Problem
  3. Transmission Engaged At High Throttle Angle Problem
  4. Cruise Inhibit Control Circuit Problem
  5. TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Now, clear the codes and test-drive the vehicle to see if the code is reset.

Process Tips

Diagnostic trouble code C1175 Nissan Rogue 2 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C1175 Nissan Rogue 2.

Fortunately, C1175 Nissan Rogue 2 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2021 - https://diagnosticTrouble.com

Small Logo