C0937 Subaru R2 Diagnostic Trouble Code

C0937 Subaru R2 code definition:
C0937 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for Subaru R2.

C0937 Subaru R2 is described as Oxygen Sensor Circuit No Activity Detected (Bank 1, Sensor 1). This means there's a problem in the front oxygen sensor on Bank 1, as the O2 sensor is inactive. As you drive and when specific conditions are slowly met, the vapors will gradually purge from the charcoal canister and will get burned within your engine.

Symptoms

Symptoms of a C0937 Subaru R2 diagnostic trouble code may include:

Excessive exhaust leak
Hesitation upon acceleration
Malfunction Indicator Lamp (MIL) illuminated
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code C0937 Subaru R2 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C0937 Subaru R2.

Fortunately, C0937 Subaru R2 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.