C0174 GMC Yukon Diagnostic Trouble Code

C0174 GMC Yukon code definition:
C0174 is a kind of OBD-II Diagnostic C-Chassis Diagnostic Trouble Code for GMC Yukon.

C0174 GMC Yukon is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a C0174 GMC Yukon diagnostic trouble code may include:
  • Lack of power
  • Faulty O2 Sensor
  • Poor acceleration
  • If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Place of C0174 in engine

Possible Causes :

  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • Faulty IMRC actuator relay (if equipped)
  • Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.

Common Misdiagnoses

  1. Crankshaft Position Sensor Circuit Performance Problem
  2. TP Sensor Learn Not Complete Problem
  3. Low Coolant Circuit Problem
  4. Cruise Control System - Vehicle Accel Too High Problem
  5. Kick-Down Switch Failed Short Problem

Repair Processes :

Use the DVOM to test resistance and continuity on all system circuits if actuator and sensor resistance levels are in compliance with manufacturer's specifications. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code C0174 GMC Yukon is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before C0174 GMC Yukon.

Fortunately, C0174 GMC Yukon is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2020 - https://diagnosticTrouble.com

Small Logo