B3901 Subaru Outback 3 Diagnostic Trouble Code

B3901 Subaru Outback 3 code definition:
B3901 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Subaru Outback 3.

B3901 Subaru Outback 3 shows up when there's an electrical problem that causes the fuel volume regulator to malfunction and open. It's quite an unusual problem and likely intermittent. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a B3901 Subaru Outback 3 diagnostic trouble code may include:

Misfire
Misfire
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Reduction in engine performance, especially at low RPM levels

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Now, clear the codes and test-drive the vehicle to see if the code is reset. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code B3901 Subaru Outback 3 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B3901 Subaru Outback 3.

Fortunately, B3901 Subaru Outback 3 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.