B3571 Ford Concept Diagnostic Trouble Code

B3571 Ford Concept code definition:
B3571 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Ford Concept.

B3571 Ford Concept is described as Fuel Rail Pressure Sensor Circuit Malfunction. This code is strictly about the incoming signal from the FRP (fuel rail pressure) sensor falling below the calibrated limit for a certain period of time. As you drive and when specific conditions are slowly met, the vapors will gradually purge from the charcoal canister and will get burned within your engine.

Symptoms

Symptoms of a B3571 Ford Concept diagnostic trouble code may include:

Poor fuel economy
Possible spark knock (detonation / pre-ignition)
Misfire
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Look for damage to the tank indicating impact that may have damaged the fuel pump or sender. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve.

Process Tips

Diagnostic trouble code B3571 Ford Concept is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B3571 Ford Concept.

Fortunately, B3571 Ford Concept is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.