B3493 Abarth Ot Diagnostic Trouble Code

B3493 Abarth Ot code definition:
B3493 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Abarth Ot.

B3493 Abarth Ot is described as Oxygen Sensor Circuit No Activity Detected Bank 2 Sensor 1. This code appears when the PCM (powertrain control module, also known as ECM or engine control module in other brands) remains at or close the 0.450 set voltage point. As you drive and when specific conditions are slowly met, the vapors will gradually purge from the charcoal canister and will get burned within your engine.

Symptoms

Symptoms of a B3493 Abarth Ot diagnostic trouble code may include:

Blown fuse (if applicable)
Engine surge
Reduction in engine performance, especially at low RPM levels
Hesitation upon acceleration

Possible Causes :

Some aftermarket accessories and performance modifications
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Dirty air cleaner element Damaged DPF

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors.

Process Tips

Diagnostic trouble code B3493 Abarth Ot is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B3493 Abarth Ot.

Fortunately, B3493 Abarth Ot is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.