B3389 Mitsubishi L200 Diagnostic Trouble Code

B3389 Mitsubishi L200 code definition:
B3389 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Mitsubishi L200.

B3389 Mitsubishi L200 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a B3389 Mitsubishi L200 diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Diminished fuel efficiency

Possible Causes :

Fuel with a large percentage of sulfur will clog the DPF quickly
The Mass Airflow sensor will also cause this problem. Mass Airflow circuit malfunction.
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Look for damage to the tank indicating impact that may have damaged the fuel pump or sender. Look at the plug wires to make sure they are not burnt or laying on the exhaust. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.

Process Tips

Diagnostic trouble code B3389 Mitsubishi L200 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B3389 Mitsubishi L200.

Fortunately, B3389 Mitsubishi L200 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.