B2967 Daimler Conquest Diagnostic Trouble Code

B2967 Daimler Conquest code definition:
B2967 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Daimler Conquest.

B2967 Daimler Conquest is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a B2967 Daimler Conquest diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code B2967 Daimler Conquest is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B2967 Daimler Conquest.

Fortunately, B2967 Daimler Conquest is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.