B2963 Ford Shelby Diagnostic Trouble Code

B2963 Ford Shelby code definition:
B2963 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Ford Shelby.

B2963 Ford Shelby is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a B2963 Ford Shelby diagnostic trouble code may include:

Lack of power
Faulty O2 Sensor
Poor acceleration
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors.

Process Tips

Diagnostic trouble code B2963 Ford Shelby is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B2963 Ford Shelby.

Fortunately, B2963 Ford Shelby is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.