B2703 Toyota Model F Diagnostic Trouble Code

B2703 Toyota Model F code definition:
B2703 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Toyota Model F.

B2703 Toyota Model F is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a B2703 Toyota Model F diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code B2703 Toyota Model F is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B2703 Toyota Model F.

Fortunately, B2703 Toyota Model F is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.