B2645 Sunbeam 3 Diagnostic Trouble Code

B2645 Sunbeam 3 code definition:
B2645 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Sunbeam 3.

B2645 Sunbeam 3 is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. So if the problem persists despite of your diagnosis, then you should never hesitate to take your vehicle to your dealer or to a qualified mechanic.

Symptoms

Symptoms of a B2645 Sunbeam 3 diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. If all testing has passed so far yet you still have the same code, check your scan tool and see if it can open and close the IMRC valve.

Process Tips

Diagnostic trouble code B2645 Sunbeam 3 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B2645 Sunbeam 3.

Fortunately, B2645 Sunbeam 3 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.