B244E Gmc Savana Diagnostic Trouble Code

B244E Gmc Savana code definition:
B244E is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Gmc Savana.

B244E Gmc Savana is defined as Ignition Coil B Primary/Secondary Circuit Malfunction.This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II tool, or vehicles made since 1996 up to present. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a B244E Gmc Savana diagnostic trouble code may include:

Fuel pressure too low
Rich or lean exhaust
Diminished fuel efficiency
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Faulty IMRC actuator/sensor

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition.

Process Tips

Diagnostic trouble code B244E Gmc Savana is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B244E Gmc Savana.

Fortunately, B244E Gmc Savana is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.