B2137 Toyota Crown Diagnostic Trouble Code

B2137 Toyota Crown code definition:
B2137 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Toyota Crown.

B2137 Toyota Crown is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a B2137 Toyota Crown diagnostic trouble code may include:

Lack of power
Faulty O2 Sensor
Poor acceleration
Hesitation upon acceleration

Possible Causes :

Some aftermarket accessories and performance modifications
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.

Process Tips

Diagnostic trouble code B2137 Toyota Crown is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B2137 Toyota Crown.

Fortunately, B2137 Toyota Crown is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.