B2118 Allard K1 Diagnostic Trouble Code

B2118 Allard K1 code definition:
B2118 is a kind of OBD-II Diagnostic B-Body Diagnostic Trouble Code for Allard K1.

B2118 Allard K1 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a B2118 Allard K1 diagnostic trouble code may include:

Faulty O2 Sensor
Lack of power
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data.

Process Tips

Diagnostic trouble code B2118 Allard K1 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B2118 Allard K1.

Fortunately, B2118 Allard K1 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.