B203F Packard Clipper shows up when there's an electrical problem that causes the fuel volume regulator to malfunction and open. It's quite an unusual problem and likely intermittent. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.
Possible Causes :
|
Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.
Diagnostic trouble code B203F Packard Clipper is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.
Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before B203F Packard Clipper.
Fortunately, B203F Packard Clipper is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.